Licensed & insured · NC electrical contractor
Mon–Fri 8AM–5PM · Emergency 24/7
Licensed & insured · NC electrical contractor
Mon–Fri 8AM–5PM · Emergency 24/7
The licensed electrician Fayetteville homeowners, landlords and builders call for panel upgrades, surge protection, generators and full house wiring. Every job is permitted, inspected and priced in writing before we start.
Emergency service
Licensed & insured
Cities served
Owners on every job
Finding an electrician in Fayetteville, NC who answers the phone, shows up on the day and prices the job in writing should not be difficult — but most homeowners have a story about the one who did none of those things.
East Point Electric is a licensed and insured North Carolina electrical contractor built to be the opposite of that: owner-run crews, permitted work, and county inspection on every job.
Much of Cumberland County was built between the 1950s and the 1980s, when a 100-amp service was considered generous. Those same houses now run heat pumps, induction ranges, hot tubs and electric vehicles off panels that were never sized for the load — and Coastal Plain storms, summer lightning and year-round humidity do the rest. That is why panel upgrades, surge protection and standby generators make up most of what we install.
We work for homeowners, landlords, remodelling contractors and builders across sixteen cities in eastern North Carolina.
These four jobs make up the bulk of our week. Each one has its own page with pricing factors, timelines and what the work actually involves.
When breakers trip under normal load, or the panel is a fuse box or a Federal Pacific unit your insurer has flagged, the service is the problem — not the appliance. We replace it, permit it and meet the inspector.
We work for homeowners, landlords, remodelling contractors and builders across sixteen cities in eastern North Carolina.
A standby generator starts itself when the grid drops and hands power back when it returns — no cords, no backfeed risk. We size it with a load calculation, then handle the generator, the pad, the transfer switch and the electrical work.
Renovation electrical goes wrong when it is planned late. Kitchens need dedicated appliance circuits, bathrooms need GFCI and vents, additions need old wiring brought to NEC code.
Fayetteville has no shortage of electricians. What separates East Point is that the people who quote the job are the people who wire it.
Full rough-in through trim-out for custom homes and spec builds. We sequence to the builder’s schedule and are on site when the inspector is.
A burning smell, a breaker that will not reset, half the house dark after a storm. Call any time and you reach a licensed electrician, not an answering service.
Cloth, aluminium and knob-and-tube wiring replaced to NEC code — the work insurers ask for before renewing a policy on a mid-century house.
Level 2 charging for every brand on a dedicated 240-volt circuit. We run the load calculation before quoting, so you know whether the panel can carry it.
Three-phase power, tenant improvements, code corrections and service upgrades for retail, office, warehouse and light industrial sites.
Cloth, aluminium and knob-and-tube wiring replaced to NEC code — the work insurers ask for before renewing a policy on a mid-century house.
New circuits, GFCI and AFCI protection, appliance runs, and diagnostics on the faults two other electricians could not trace.
Pre-purchase and safety inspections with a written report for your lender, insurer or buyer. Worth doing on any house built before 1990.
Ceiling fans, bath vents, smart switches and appliance circuits — the smaller jobs most contractors will not book on their own.
Text us the offer you want and we will apply it to your written quote. One offer per job.
Fayetteville has no shortage of electricians. What separates East Point is that the people who quote the job are the people who wire it.
We hold a North Carolina electrical contractor licence and carry full liability and workers’ compensation cover. Check it with the NC Board of Examiners before you book — we would rather you did.
We price the job, not the hour. You get a written scope and a firm figure, and nothing starts until you approve it. No hourly meter, no additions at the end.
Panel upgrades, rewires and new services are permitted and signed off by the county inspector. That record protects your insurance claim and follows the house to closing.
Boris and JB run the crews themselves. No call centre sits between your problem and the electrician solving it — which is why most of our work comes through referrals.
Common breakers, devices, fixtures and wire ride with the crew, so most service calls finish the day they start.
We work to the general contractor’s sequence, hit rough-in and trim-out dates, and are on site when the inspector arrives.
“The panel was never the complaint. It was the cause.”
A homeowner called about a breaker that had tripped three times in a week. A 1960s brick ranch, original 100-amp panel, one circuit feeding a converted home office.
The load calculation showed that circuit was also carrying a bathroom and a bedroom — normal when the house was built, fine until a second monitor, a printer and a space heater joined it. The breaker was not faulty. It was doing its job.
We ran a dedicated 20-amp circuit for the office, replaced two breakers showing heat damage on the bus, and priced a 200-amp upgrade separately for the owner to consider. Permitted, inspected, finished the same day.
That is the pattern here: the symptom is one circuit, the cause is a service sized for a different decade. Finding the difference is what you are paying an electrician for.
We are based in Fayetteville and work across sixteen cities in seven counties — Cumberland, Harnett, Lee, Wake, Sampson, Bladen and Hoke. Each city below has its own page with local detail on permits and the work we do there.
TALK TO AN OWNER
Hours
Yes. We hold a North Carolina electrical contractor licence and carry full liability insurance and workers’ compensation cover. Every job that requires a permit is inspected by the county, and you can verify our licence with the NC Board of Examiners before you book.
We price the job, not the hour. After assessing the work on site you receive a written scope and a firm price, and nothing begins until you approve it, so there is no hourly meter and nothing added at the end.
It depends on the service size, the condition of the existing wiring, mast and meter base, and the county permit fee. Those vary house to house, so we quote in writing after an on-site assessment. Most residential upgrades finish in a single day.
Breakers that trip repeatedly or will not reset, a burning smell or scorching, rust or a warm panel, lights that dim when the air handler starts, and no space for new circuits. Fuse boxes and Federal Pacific panels should be replaced regardless — many insurers refuse to cover them.
In this part of the state, yes. A panel-mounted device costs a fraction of one HVAC control board and protects everything on the panel. Given the summer lightning and hurricane-season storms, most customers add it while the panel is already open.
Yes. We handle full rough-in through trim-out on custom homes and spec builds, and wire kitchens, bathrooms, additions and bonus rooms on renovations — working to the general contractor’s sequence and dates.
Yes. Burning smells, sparking outlets, dead circuits and storm damage do not wait for business hours, so we do not either. Call 910.850.1762 at any time and you reach a licensed electrician.
Fayetteville, Sanford, Lillington, Raleigh, Fuquay-Varina, Linden, Wade, Eastover, Stedman, Clinton, White Oak, White Lake, Elizabethtown, Hopemills, Vandor and Raeford — across seven counties. If you are not sure whether your address falls inside that, call and ask.
Tell us what is wrong and we will tell you what it costs, in writing, before anything starts. Licensed, insured and working across sixteen cities in eastern North Carolina — with emergency service around the clock.